• Trowel on, 2 part epoxy system for extreme, durable, long lasting solution.
• For industries, such as breweries, canneries, or off-shore drilling platforms.
• Extra thick consistency requires trowel and squeegee application.
• Packed 1 gallon kit per case.
• 25 - 30 square feet coverage per gallon.
• No flash or volatile solvents, low voc.
• 18 - 24 hour cure time.
• 30 - 60 minute pot life once mixed.
• Squeegee and mixing blade not included.
  

• Drainage holes allow liquids and waste to pass through matting.
• Comfortable construction eases fatigue and increases productivity.
• Heavy duty 7/8" thick rubber construction for wet enviroments.
• Available in a grease resistant black or a red greaseproof mat.
• Black is also available with a grit coated surface for extra traction.

• Crystal clear mats that let the beauty of your fine carpeting or flooring be seen, but protected from dirt and marring.
• These mats are constructed of an acrylic sheet with smooth rounded edges.
• Available in 1/4" or 3/8" thickness.
• Custom cut to your specifications.
• Mats can not be shipped UPS.
• Acrylic mats carry no warranty.

• Made of extruded 6063 aluminum alloy and are fabricated to exact dimensions to insure fit to the mat.
• Frames are supplied with mitered corners and shipped unassembled with all necessary anchor keys and corner pins.
• Frames must be assembled at the job site and installed so that upper edge is level with finished floor surface.
• The frame should be anchored into cement with anchor keys a minimum of 24" on centers.
• Corner pins should be installed at all corners of frame.
• For use on mats of 3/8" - 5/8" thickness
• "Dimensions" are inside frame dimensions.

• Our renovation treads are manufactured of high quality, heavy duty extruded aluminum with our exclusive safety traction surface.
• 9" or 11" depth covers most applcations.
• 9/32" thick with 1 1/8" nose.
• 9" treads available up to 144' in one section and 11" treads available up to 96' in one section.
• Treads install easily over existing worn stairways of concrete, wood, steel or terrazzo.
• Available with optional sightline or glow in the dark front edge at an additional cost.
• Holes are drilled and countersunk unless otherwise specified.

• Our anchor mat sits still, even if you don't.
• Mat has hundreds of rigid anchors that hold the mat in place.
• The textured surface facilitates easy but controlled movement of caster chairs.
• The vinyl material is scuff-resistant and is transparent to let the beauty of your carpet show through.
• Available in 3/16" and 1/4" thickness.
• 3/16" material is available in rolls up to 50' in length.

• Outdoor Recycled Rubber Stair Tread is an excellent tread for exterior applications.
• Made from 100% recycled tires.
• Diamond design surface is 9" deep with a 3" smooth back border.
• Full 1/4" thickness at the nose, 12 1/4" depth and a 1 1/4" deep inside nose.
• Available in square nose only.

• Medium duty stair tread.
• This tread was designed for use in apartment projects and light commercial applications. 
  
• Lower initial cost, ease of installation, ease of cleaning and long service appeals to apartment owners and builders.
• Extra thick at the front, Meets Fed. Spec. RR-T-650E Type B.
• 3/16" thick, 12" deep, 1 1/4" square or curved nose.
• Contains no asbestos fiber, made of first quality homogeneous vinyl, color throughout.
• Specify either square or curved nose.
  

• New design Adjusta-Nose tread easily adjust to steps with angle between 90^o and 60^o.
• Ideal for public buildings where fire safety is a prime concern.
• For use in commercial, industrial or institutional buildings.
• Circular disc, 3/4" diameter, are easy to clean and affords for safer pedestrian traffic.
• Meets Fed. Spec. RR-T-650E.
• Flame spread rating of 25 or less using ASTM-E-84 test.
• Full 1/4" thickness at the nose, 12 1/2" depth and a 1 7/8" deep inside nose, smooth rear border is 3" deep.
• Contains no asbestos fiber and the color extends throughout the thickness of the tread.
  
• Available in standard solid color from Color Series III only.
• Treads are optionally available with either two 3/4" safety strips, one 2" safety strip, or one 2" photoluminescent strip.
• Strips are available in black, beige, brown, gray, red or yellow.

• The original diamond design molded rubber stair tread, half diamond design, half smooth, with a longer adjustable nose.
• Designed to fit pan filled, molded concrete, or terrazzo steps.
• For use in commercial, industrial or institutional buildings.
• Diamond design surface is 6" deep, covers the impact area of pedestrian traffic.
• Meets Fed. Spec. RR-T-650E and ZZ-T-001237 (GSA-FSS)
• Full 1/4" thickness at the nose,12 1/4" depth and a 1 1/4" deep inside nose.
• Contains no asbestos fiber and the color extends throughout the thickness of the tread.
• Available in either square or curved nose.
• Curved nose available in Series I colors only.
• Treads are optionally available with either two 3/4" safety strips, one 2" safety strip, or one 2" photoluminescent strip.
• Strips are available in black, beige, brown, gray, red or yellow.

• Rubberized, textured non-slip is designed for heavy shoe traffic, yet is comfortable enough for bare feet.
• Provides unparalleled coefficient of friction in both industrial and commercial applications.
• Coated with an aggressive adhesive designed with industrial and commercial applications in mind.
• National Flooring Safety Institute Certified for "high traction".
• Available in black or gray.
• Sold in full cases only.

Related Products: #3520